Darex XT-3000A - Manual (Page 67)

65
Mounting Auto
Controller/
Display to
Base Casting:
1. Install and tighten
the two, 6mm BHSHC
screws from the stamped bracket to the control
box.
2. Align control box to main casting and transfer
punch or mark for drilling mounting screw holes.
3. Drill through
casting.
4. Using the alcohol wipe provided, thoroughly
clean the XT base casting surface where the ad-
hesive will make contact.
5. Peel adhe-
sive backing
from dual-lock
tape.
6. Carefully
align Controller/
Display to XT
base casting
and press
firmly.
5. Using 2, 10-24 thread forming screws,
insert into mounting bracket. While push-
ing hard, drive
in screws until
seated.
Caution don’t drill into motor housing