FEC AFC1100 - Manual (Page 14)

)(& ,QF
SV ERROR 2 DATA 7
SV ERROR 1 DATA 6
Outputs a detailed code when a SV AMP
ERR is output. Error code is output in three
bits. (See Section 4.7.3 ). SV ERROR 0 DATA 5
Outputs when a servo abnormality occurs,
see SV ERR 0~2 codes below. SV AMP ERR DATA 4
Outputs when a tool related abnormality
occurs. TOOL ERR DATA 3
Outputs when an abnormal condition occurs
in the encoder. ENC ERR DATA 2
Outputs when an abnormal condition occurs
in the parameter setting. PSET ERR. DATA 1
Outputs when an abnormal condition occurs
during the SELF CHECK (CAL and Zero). ZERO CAL
ERR DATA 0 ON ON 4
not used DATA 7
not used DATA 6
Output when Fastening resulted in a 2nd
Torque Rate Low Reject. 2ND RATE
LOW REJECT
DATA 5
Output when Fastening resulted in a 2nd
Torque Rate High Reject. 2ND RATE
HIGH REJECT
DATA 4
Output when Fastening resulted in a 1st
Torque Rate Low Reject. 1ST RATE
LOW REJECT
DATA 3
Output when Fastening resulted in a 1st
Torque Rate High Reject. 1ST RATE
HIGH REJECT
DATA 2
Output when Fastening resulted in an Angle
Low Reject. ANGLE LOW
REJECT
DATA 1
Output when Fastening resulted in an Angle
High Reject. ANGLE HIGH
REJECT
DATA 0 OFF ON 3
DESCRIPTION
NAME OF
SIGNAL
BANK DATA
PINS 25 ~ 18
0
PIN 13
1
PIN12
BANK
#
PLC / AXIS UNIT BANK DATA BANK
SELECT
INPUT
Chapter 4: System Setup and Wiring (Rev. 8/98)
Page 4-14