E-Mon E20-6003200J-D-KIT - Manual (Page 23)

CLASS 2000 METER
23 62-0389-05
6.3 KWh Meter Hardware Functions
Fig. 18. Hardware Functions.
IDR Jack 8-pin RJ-45-used to connect kWh meter to the E-Mon
Energy automatic meter reading system.
Pulse Output Optically isolated output pulse for connection to BAS or
peripheral equipment.
Calibration Jack Connector J11 is for factory calibration only, and is not
a user accessible port. Silicon plug is not to be
removed.
Reset Resets kWh and kW demand.
Power On LED When lit, indicates power to meter is on.
Meter Pulse LED Blinks to show the meter load. Blink rate increases with
load.
Error LED When lit, indicates that the current sensor is backwards
or on the incorrect phase.
M33212
ERROR
LED
METER
PULSE LED
POWER
ON LED
IDR JACK
PULSE OUTPUT CALIBRATION
JACK
SEE
DESCRIPTIONS
ABOVE
HEADER
CONNECTOR
(CURRENT
SENSORS)
MAIN
POWER
TERMINAL
BLOCK
RESET BUTTON