Teledyne PEM-9004 - Portable emissions analyzer - Manual (Page 35)

Portable Emissions Analyzer Operation
Teledyne Analytical Instruments 23
4.4.2 Fuel
The Fuel menu is used to add or remove a fuel from the list of
available fuels stored in the analyzer’s memory. Up to five additional
fuels can be configured and stored in the list. To enter the Fuel menu
press F2 from the Configuration menu. The following screen appears:
From this screen you can remove a fuel from the list, add a fuel to
the list or include all the fuels programmed into the analyzer memory
including those that have been removed.
4.4.2.1 R EMOVE A F UEL FROM THE L IST
•
Press the button corresponding to “Remove”. The fuel that is
highlighted in the frame will be removed from the list.
Note: The removed fuel can be reinstated using the “Include all”
function.
4.4.2.2 R EINSTATE A P REVIOUSLY R EMOVED F UEL
•
Press the button corresponding to “Include all”. Any
previously removed fuel will be reinstated in the fuel list.
It is possible to add up to 5 additional fuels to the preinstalled list of
fuels. In order to create a new fuel the first three fuel-specific factors
(CO
2max
, A2 and B) have to be entered. If units than ppm or % are used
additional factors must be entered in order to perform the conversion to
mg/m
3
, mg/kWh or MJ/m
3
correctly.