Teledyne 5000B - Near Infrared Photometer - Manual (Page 28)

2-10: Part I
Teledyne Analytical Instruments
1 Introduction Model 5000B
• Check that sample pressure typically between 0 and 30 psig,
according to the requirements of your process.
Power up the system, and test it by performing the following operation:
1. Repeat the Self-Diagnostic Test.
2. Zero the instrument.
3. Span the instrument.
Consult calibration recommendation in the addendum for your
particular application whether liquid or gas phase monitoring.
For steps 2 and 3, refer to part II for calibration.