Teledyne 3010TAC - Split architecture trace oxygen analyzer (EU - CENELEC) - Manual (Page 10)

ii: Part I
Model 3010TAC Oxygen Analyzer
Teledyne Analytical Instruments
Table of Contents
1 Introduction
1.1 Overview ........................................................................ 1-1
1.2 Control Unit Front Panel ................................................. 1-1
1.3 Recognizing Difference Between LCD & VFD ............... 1-3
1.4 Control Unit Rear Panel ................................................. 1-3
2 Operational Theory
2.1 Introduction .................................................................... 2-1
2.2 Electronics and Signal Processing ................................ 2-1
3 Installation
3.1 Unpacking the Control Unit ............................................ 3-1
3.2 Mounting the Control Unit .............................................. 3-1
3.3 Electrical Connections ................................................... 3-3
3.3.1 Primary Input Power .............................................. 3-4
3.3.2 50-Pin Interface Connector ................................... 3-4
3.3.3 RS-232 Port ......................................................... 3-9
3.3.4 Remote Probe Connection ................................... 3-10
3.4 Testing the System ......................................................... 3-11
4 Operation
4.1 Introduction .................................................................... 4-1
4.2 Using the Data Entry and Function Buttons ................... 4-2
4.3 The System Function ..................................................... 4-3
4.3.1 Tracking the O
2
Readings during Calibration ......... 4-4
4.3.2 Setting up an Auto-Cal ........................................... 4-5
4.3.3 Password Protection .............................................. 4-5
4.3.3.1 Entering the Password ................................... 4-6
4.3.3.2 Installing or Changing the Password ............. 4-7
4.3.4 Logout .................................................................... 4-8
4.3.5 System Self-Diagnostic Test .................................. 4-9