Teledyne 3010PAC - Split architecture percent oxygen analyzer (EU - CENELEC) - Manual (Page 35)

Oxygen Analyzer Part I: Control Unit
Part I: 4-1 Teledyne Analytical Instruments
Operation
4.1 Introduction
Once the analyzer has been installed, configure it for your process. To
do this you can:
• Set system parameters—
• Specify a password, if desired, requiring operator to log in.
• Establish and start an automatic calibration cycle, if desired.
• Calibrate the instrument.
• Define the three user selectable analysis ranges. Then choose
autoranging or select a fixed range of analysis, as required.
• Set alarm setpoints, and modes (latching, failsafe, etc).
Before configuration these default values are in effect:
PARAMETER DEFAULT
LO Range 1 %
MED Range 5 %
HI Range 10 %
Auto Ranging ON
Alarm Relays 10 %
(Defeated, HI, Not failsafe, Not latching)
Span 20.9 %
(Auto, every 0 days at 0 hours)
Zero (Auto, every 0 days at 0 hours).
If you choose not to use password protection, the default password is
automatically displayed on the password screen when you start up, and you
simply press
Enter for access to all functions of the analyzer.