Teledyne 3000PB - Bulkhead mount percent oxygen analyzer - Manual (Page 15)

1-9
Percent Oxygen Analyzer Introduction 1
Teledyne Analytical Instruments
• RS-232 Port Serial digital concentration signal output
and control input.
• Remote Valves Used for controlling external solenoid
valves, if desired.
• Remote Sensor Used for external sensor and thermistor
• Remote Span/Zero Digital inputs allow external control of
analyzer calibration.
• Calibration Contact To notify external equipment that
instrument is being calibrated and
readings are not monitoring sample.
• Range ID Contacts Four separate, dedicated, range relay
contacts. Low, Medium, High, Cal.
• Network I/O Serial digital communications for local
network access. For future expansion.
Not implemented at this printing.
1.7.2 Gas Connector Panel
The gas connector panel, shown in Figure 1-4, contains the gas con-
nections for external inlets and outlets. Those that are optional are shown
shaded in the figure. The connectors are described briefly here and in detail
in the Installation chapter of this manual.
Figure 1-4: Model 3000PB Gas Connector Panel
Note:
For Additional information,
please, see page 1-4