Teledyne 2000A-EU - General purpose thermal conductivity analyzer - Manual (Page 3)

iii
Thermal Conductivity Analyzer
Specific Model Information
The instrument for which this manual was supplied may incorporate one or more
options not supplied in the standard instrument. Commonly available options are listed
below, with check boxes. Any that are incorporated in the instrument for which this
manual is supplied are indicated by a check mark in the box.
Instrument Serial Number: _______________________
Options Available with Order:
❑ ❑ ❑ ❑ ❑ 2000A-C: Auto Calibration valves (zero/span) built-in gas selector panel
and control valves are electronically controlled to provide
synchronization with the analyzer’s operations.
❑ ❑ ❑ ❑ ❑ 2000A-G: Stainless steel cell block with nickel filaments and Stainless
Steel fittings and tubing.
❑ ❑ ❑ ❑ ❑ 2000A-H: Stainless steel cell block with gold filaments for corrosive gas
streams and Stainless Steel fittings and tubing.
❑ ❑ ❑ ❑ ❑ 2000A-K: 19" Rack Mount available with either one or two analyzers
Control Units installed and ready to mount in a standard rack
❑ ❑ ❑ ❑ ❑ 2000A-L: Gas selector panel consisting of sample/ref flow meters and
control valves for metering input of sample/calibrations
support gases
❑ ❑ ❑ ❑ ❑ 2000A-R: Sealed reference cell (application dependent, contact factory).
❑ ❑ ❑ ❑ ❑ 2000A-N: 220 VAC operation.