PASCO UI-5000 850 Universal Interface Instruction Manual - Manual (Page 6)

850 Universal Interface UI-5000
® ® 6 012-12355A
3. Connect the smaller end of the USB cable to the USB port on the
back of the interface.
4. Connect the AC adapter plug to the power jack on the back of the
interface box. Connect the AC adapter power cord to a grounded
wall outlet.
C. Starting the 850 Universal Interface
1. On the left front corner of the interface, firmly press and hold the
power push button. The interface will “beep” once and the green
light emitting diodes (LEDs) above the PASPORT input ports will
blink once. The push button has a blue LED that shines when the
power is on.
2. The green LED connection indicator below the power push button
should light up. If not, check the connection between the interface
and the computer.
D. Plugging a Sensor into the 850 Universal Interface
• PASPORT sensors plug into input ports labeled .
• ScienceWorkshop analog sensors with DIN connectors plug
into the ANALOG INPUTS labeled A, B, C, and D on the
interface.
• ScienceWorkshop digital sensors with stereo phono plugs connect into the DIGITAL INPUTS
labeled 1, 2, 3, and 4 on the interface.
Extender Cables
If you need extra distance
between the sensor and the
850 Universal Interface, use an
extender cable such as the
UI-5218 8 pin 1.8 m DIN
Extender Cable, the PS-2500
PASPORT Sensor Extension
Cable, or the PI-8117 Phono Jack Extender Cable.
Power jack
1, Power
push button
2, LED
connection
indicator
1.
2.
USB port
phono plug
DIN
plugs
PASPORT
plugs
UI-5218 DIN
Extender Cable
PS-2500 PASPORT
Extension Cable
PI-8117 Phono Jack
Extender Cable