beautypg.com

Method #2, Method #3, Sweep type and frequency – PASCO UI-5000 850 Universal Interface Instruction Manual User Manual

Page 14

background image

850 Universal Interface

UI-5000

®

®

14

012-12355A

Method #2

• Use the Up and Down arrows to increase or decrease the individual digits. Use the Left and

Right arrows to select the digit to change. By default, the “ones” (10

0

) digit is selected..

• Each click on the Up or Down arrows increases or decreases the highlighted digit by “1”.

• Click the Left arrow to move the selection of the highlighted digit to the left. The left-most

digit that can be highlighted for Frequency is the “hundred-thousands” (10

5

) digit. Click the

Right arrow to move the selection of the highlighted digit to the right. The right-most digit

that can be highlighted is the “thousandths” (10

-3

) digit.

Method #3

• Click the Expression menu icon (

) to open the Expression menu.

Select Choose Expression to select a calculation that has already been
created from the submenu, or select Create Expression to build a
calculation in the Frequency or Amplitude text areas. Click Use
Expression to make the choice active.

Sweep Type and Frequency

If you want the output frequency to change automatically
from one frequency to another in specified increments
over a selected time, select Single, Repeat, or
Bidirectional from the Sweep Type menu.

• The Single Sweep Type starts at the

Initial Frequency (default = 10 Hz) and moves to the
Final Frequency (default = 100 Hz) in the time
shown in Duration (default = 5 s), and with each new
frequency increased or decreased by the amount
shown in Step Frequency (default = 0.1 Hz).

• The Amplitude range is 0 (default) to 15 V. The Frequency ranges are the same as before.

The Duration range is from 0.00001 to 10000 seconds.

• The Repeat Sweep Type behaves the same was as the Single Sweep Type, except that it

repeats itself continuously while the Signal Generator output is on.

Left and Right

arrows

Up and Down

arrows

Expression

menu

Click Left

arrow

Click Right

arrow

Right-most

selectable digit

Left-most selectable digit

(for frequency)

Sweep Type: Single