ATI Technologies ALL-IN-WONDER 9700 - Manual (Page 18)

12 Installing the Hardware and Software
4 Remove any existing graphics card from your computer.
If your computer has an on-board graphics capability, you
may need to disable it on the motherboard. For more
information, see your computer documentation or contact
the manufacturer.
Power connection requirements
After removing the old video card and software, refer to the
illustration on
page 13 , and use the supplied Power Extension
Cable to connect the ALL-IN-WONDER 9700 Series card to
your computer’s Hard Drive power connector.
1 Remove the power cable from the Hard Drive, then connect
A of the Power Extension Cable to the graphics card power
connector as shown. (The cable may already be connected
to the graphics card.)
2 Connect B to the power supply connector, then connect C
to the Hard Drive power connector.
3 After locating the AGP slot, and if necessary, removing the
metal cover, align your ALL-IN-WONDER 9700 Series
card with the AGP slot, and press it in firmly until the card
is fully seated.
4 Replace the screw to fasten the card in place, and replace
the computer cover.
5 Plug the monitor cable into your card.
The ALL-IN-WONDER 9700 Series cards require
connection to your PC’s internal power supply for
operation. A 300W power supply or greater is
recommended to ensure normal system operation
where a number of other internal devices are
installed.
• Please check the sticker on your power supply to
determine the wattage.