Diamond Products FZ-4S - Manual (Page 6)

Safety instructions FZ-4S
Page 6 FZ-4S_e_0205.fm
0DWHULDOV VXLWDEOH IRU SURFHVVLQJ
2QO\
the following materials are to be
machined by HYDROSTRESS equipment:
z
&RQFUHWH DQG QDWXUDO VWRQH
Other materials are
QRW WR EH SURFHVVHG
.
Especially do not process:
- Wood, plastics and glass
&RQFUHWH DQG VWRQH FXWRXWV RU GULOOLQJ
FRUHV
These pieces can be very heavy.
1m³= 2400-2700 kg
Example:
A cube of concrete measuring 0.5 by 0.5 by
0.5 m weighs about 300 kg. A drilling core with
a diameter of 30 cm and a length of 1 m
weighs about 180 kg.
Make sure that these pieces cannot fall or tip
over and cordon off the hazardous area.
6DIHW\ FRPSRQHQWV
Never start up the machine without fitting the
correct safety components (see “Safety
components” section of these operating
instructions manual).
&RQWUROV DQG DFFHVVRULHV
Use the machine only with the recommended
controllers or devices and accessories (see
“Connectable Controls” and “Accessories” in
this manual).
/RFDO VDIHW\ UHJXODWLRQV
Pay attention to the general and specific safety
regulations of your local trade associations.