Fz-4s set-up – Diamond Products FZ-4S User Manual
Page 21
FZ-4S
Set-up
FZ-4S_e_0205.fm
Page 21
3URFHGXUH
z
Mark cutting line on the concrete
z
Mark dowel line at a distance of 22 cm.
(The same distance applies for flush cuts)
z
Drill dowel hole and fit dowel according to
dowel manufacturer’s instructions
z
Mount V-rail supports (9) on V-rails (1).
z
Mount rail unit on concrete and align using
cut guide (10)
z
Align rail unit with adjusting foot (8), so that
all adjusting feet (8) and the adjusting
screws (4) are supported by the concrete.
z
Tighten rail unit (1)
5DLO OLPLW VWRS
z
Mount rail limit stop on the end of the rail, so
that the wall saw head cannot fall off the
rail.
Clearance between rail supports:
- where a single rail is used, as high as possible
- where a number of rails are used, evenly distributed
along the entire length of rail.
Once rail unit has been mounted
check adjusting nut (3) and
clamping block (6) anchoring
- CG-1 Mini Groover (32 pages)
- CG-2 Mini Groover (56 pages)
- CC110-DC-SS (28 pages)
- CC110D-SS (40 pages)
- CC110D-DC (44 pages)
- CC155 (12 pages)
- CC155 (28 pages)
- CC1100 (16 pages)
- CC1200 (8 pages)
- CC1300XL (38 pages)
- CC1300XL (Gas) (24 pages)
- CC1300XL (Electric) (40 pages)
- CC1507E (20 pages)
- CC1800XL (Electric) (52 pages)
- CC1800XL (Gas) (44 pages)
- CC1800XL (8 pages)
- CC2500 (Gas) (56 pages)
- CC2500 (Electric) (60 pages)
- CC3500J (68 pages)
- CC3500E (Electric) (68 pages)
- CC3500 (Gas) (68 pages)
- CC3535 (64 pages)
- CC3728 (80 pages)
- CC3700 (40 pages)
- CC3500 (4 pages)
- CC3700E (84 pages)
- CC3700E-3 Speed (72 pages)
- CC3730TE (68 pages)
- CC4120 (60 pages)
- CC4144D (36 pages)
- CC4144D (64 pages)
- CC4144D-XL (60 pages)
- CC4144D (3 Speed) (68 pages)
- CC6160D (36 pages)
- CC6500 (36 pages)
- CC2700 (4 pages)
- CC6540E (76 pages)
- CC6550XLS (76 pages)
- CC6550XLS-3 Speed (72 pages)
- CC6560XLS (88 pages)
- CC6560XLT (76 pages)
- CC6560XL (28 pages)
- CC6566 (48 pages)
- CC6566 (84 pages)
- CC6566-3 speed (80 pages)