7 saw blade unit for flush cutting, 6dz eodgh xqlw iru ioxvk fxwwlqj, Ad a e d – Diamond Products FZ-4S User Manual

Page 26

Text mode
Original mode

Saw blade unit for flush cutting

FZ-4S

Page 26

FZ-4S_e_0205.fm

6DZ EODGH XQLW IRU IOXVK FXWWLQJ

$VVHPEO\

Place saw blade with a 60 dia. hole on the
blade flange (A)

Note countersinking of the saw blade
anchoring

Secure saw blade with 6 Allen screws (D) to
blade flange (A)

(tighten screws crosswise)

If the saw blade is not properly secured, it may come loose and cause serious injury. It
is therefore essential to closely follow the instructions below.

Anchor saw blades for flush cutting using
6 countersunk head screws (D).

Use the following screws only:

Countersunk head screw M8x16,

JUDGH , order No. 97182