Diamond Products FZ-4S - Manual (Page 30)

Sawing FZ-4S
Page 30 FZ-4S_e_0205.fm
6DZLQJ
%HIRUH VDZLQJ
Follow the instructions below:
z Check direction of travel and swivelling
motion
z Teeth of rails must be clean
z “Test run”: run the wall saw head along the
entire length of the rail and check that the
hoses do not catch at any point
z Cover sharp-edged objects
z Check that all dowel screws on the rail
supports have been tightened
z Check if water is emerging at the point of
rotation of the saw blade
7KH ILUVW FXW SUHFXW
3URFHGXUH
z Move wall saw head to starting position
z Sawing
Never saw without the blade
guard.
Note:
- if possible do not cut through any reinforcements
- swivel arm pulled
- cutting depth 5-10 cm
- working pressure 100-120 bar
5-1
0
cm