Diamond Products FZ-4S User Manual
2shudwlqj lqvwuxfwlrqv 6sduh sduwv olvw
Table of contents
Document Outline
- 0.1 Introduction
- 0.2 Validity of this manual
- 0.3 Standards
- 0.4 Delimitation of the system
- 0.5 Table of contents
- 1 Safety instructions
- 1.1 Fundamentals
- 1.2 Before starting work
- 1.3 During sawing
- 1.4 After the work
- 2 Technical data
- 2.1 Dimensions
- 2.2 Measurements
- 3 Range of applications
- 3.1 Connectable units
- 3.2 Possible applications
- 4 Design and function
- 4.1 Wall sawing system design
- 4.2 Safety components
- 4.3 Rail system
- 4.4 Wall saw head design
- 4.5 Function
- 4.6 Controls and connections
- 4.7 Function (table)
- 5 Set-up
- 5.1 Initial start-up
- 5.2 Preparatory operations
- 5.3 Selecting the saw blade
- 5.4 Replacing saw motor
- 5.5 Mounting V-rails on concrete
- 5.6 Fitting wall saw head
- 5.7 Adjustment / Taking up play
- 5.8 Removing the slide guides
- 6 Saw blade unit for normal cutting
- 6.1 Saw blades of up to 1000 mm diametre
- 6.2 Saw blades over 1000 mm diametre
- 7 Saw blade unit for flush cutting
- 8 Mounting saw blade unit on wall saw
- 8.1 Mount saw blade unit
- 9 Connecting the drive units
- 10 Sawing
- 10.1 Before sawing
- 10.2 The first cut (precut)
- 10.3 After the first cut
- 10.4 Terminating the work
- 11 Disassembling saw blade unit
- 12 Troubleshooting
- 13 Maintenance
- 13.1 Maintenance table
- 13.2 Change prism guides
- 13.3 Change feed motor
- 13.4 Exchange swivelling motor
- 13.5 Change gear grease
- 13.6 Repair
- 14 Transport, taking out of service, storage, disposal
- 14.1 Transport
- 14.2 Taking out of service and storage
- 14.3 Disposal
- 15 Accessories
- 15.1 Accessories available to order
- 15.2 Hydraulic drive motors
- 16 Spare parts list
- 16.1 Ordering information