12 troubleshooting, 7urxeohvkrrwlqj – Diamond Products FZ-4S User Manual
Page 35

FZ-4S
Troubleshooting
FZ-4S_e_0205.fm
Page 35
7URXEOHVKRRWLQJ
Proceed systematically when looking for the
cause of a fault. In doing so also refer to the
operating instructions for the electric motor
and control unit(s).
If you cannot find the defect or eliminate the
faulty condition, please contact our after-sales
service.
Before calling us, please note the following:
- The more accurately you describe the fault, the better
we can help you.
- Have the operating instructions close to hand.
- Note down the serial number of your equipment.
)DXOW
3RVVLEOH FDXVH
6ROXWLRQ
Wall saw head does not move or only
moves jerkily on the rail
Slide guide tightened too hard
Loosen slide guide slightly so that slide
(without sawing) starts to move at 20 bar
Rail toothing soiled
Clean rail
Prisms worn
Exchange prisms
Guiding groove of rail warped
Replace rail
Misaligned rail joint
Use rail lock
Wrong or defective feed motor
Exchange motor
Defective feed gears
Exchange feed gears, contact
HYDROSTRESS after sales service
Hoses incorrectly coupled
See “Coupling hoses”
Defective drive unit
Check drive unit
Swivel arm does not move or only
moves jerkily
Wrong or defective feed motor
Exchange motor
Defective swivel gears
Exchange swivel gears, contact
HYDROSTRESS after sales service
Hoses incorrectly coupled
See “Coupling hoses”
Defective drive unit
Check drive unit