Diamond Products HCH50 - Manual (Page 8)

Product description Operating instructions
1-2 HCH5011 / 001
1.1.2 Intended purpose
The Chain saw HCH5011 is designed and built for the following
application:
• Cutting of concrete (including reinforced), masonry and natural stone
• Cutting of severance cuts, flush cuts and cross-cuts in ceilings, floors
and walls
• Only original TYROLIT Hydrostress AG tools (chains) should be used
The information provided in Chapter 1 “Technical Data” 1.2, 1-4
represents the mandatory usage limits and rated data
1.1.2.1 Safety measures
Any use other than for the intended purpose (see Chapter 1.1.2, 1-2)
constitutes improper use or misuse.
Since improper use or misuse can sometimes results in considerable
danger, here details of what we believe constitutes improper use or
misuse.
The following applications are prohibited:
• Cutting without the safety devices provided
• Cutting wood, glass and plastics
• Cutting without system and tool cooling
• Cutting in explosion-protected areas
• Cutting loose parts
• Incorrect or absence of waste water disposal (saw sludge)
1.1.3 Workplace and danger areas
Allow enough room for manoeuvre to ensure danger-free working.
Make sure you have sufficient lighting at your workplace.
Clearly cordon off the danger area so that no person can enter the danger
area during sawing.
The front, underneath and rear of the sawing area must be protected so
that persons or equipment cannot be harmed by falling parts or sawing
sludge, or by the protruding cutting tool.
Secure lumps of concrete that have been loosened against falling.
Breathing in the water fog that is created is a health hazard. Ensure
adequate ventilation in sealed-off areas.
The sludge resulting from cutting is very greasy. Remove this or ensure
that you or other people do not slip on it.