Diamond Products HCH50 - Manual (Page 37)

Operating instructions Operation
HCH5011 / 001 6-5
6.2 System requirements
In order to use the Chain saw HCH5011 a hydraulic drive assembly is
needed.
Drive assembly power requirements:
Minimum power: Minimum flow 35 l/min.
Max. pressure 140 bar
Maximum power: Maximum flow 45 l/min.
Max. pressure 140 bar
If the basic power of the drive assembly used is higher, a flow divider /
pressure limiter or a pressure relief valve can be used.
Operation of the individual system components is described in the
corresponding Operating instructions.
Fig. 6-1 Chain saw HCH5011 with drive assembly
1. Chain saw HCH5011 4. Main oil circuit (inlet)
2. Drive assembly 5. Main oil circuit (outlet)
3. Water feed (cooling water)
6.3 Preparatory operations
Always proceed as follows:
• Sort out fundamental conditions
• Securing the site
• Securing cutouts
• Decide on position and sequence of the cuts
• Perform a visual inspection of the Chain saw HCH5011
• Connect the Chain saw HCH5011 to the drive assembly
1
2
3
4
5