Diamond Products HCH50 - Manual (Page 36)

Operation Operating instructions
6-4 HCH5011 / 001
6.1.2 Personnel qualifications
The Chain saw HCH5011 should not be operated by unauthorised
personnel. Personnel are only authorised where they meet the following
requirements.
• Completion of concrete expert training or having professional
experience.
• Receipt of an introduction (basic training) to the operation of the Chain
saw HCH5011 from a service engineer.
• Read and understood chapter 2 “Safety instructions”.
Warning
Warning of slippery floors
The water feed and abrasion can make standing surfaces smooth
and slippery. You should therefore always ensure you have a firm
footing.
Failure to adhere to this regulation may result in slight or serious
physical injury.
Warning
Warning against working when not in a fit state to do so.
Do not use the Chain saw HCH5011 if you are under the influence
of sedatives or alcohol or if you are overtired.
Failure to adhere to this regulation may result in slight or serious
physical injury.