Diamond Products HCH50 - Manual (Page 44)

Operation Operating instructions
6-12 HCH5011 / 001
6.5 After the work
Proceed as follows:
• Close off and decouple the water feed
• Blow out water from all lines
• Remove plug from mains (drive assembly)
• Uncouple hydraulic hoses
• Clean the Chain saw HCH5011 with water
• Lubricate the chain and the bar
6.5.1 Chain and bar lubrication
Fig. 6-8 Chain and bar lubrication
Proceed as follows:
• After final use rinse chain and bar with water. Allow chain to run for 5
seconds without water
• Disconnect the Chain saw HCH5011 from the drive assembly
• Lubricate the chain and bar (chain spray)
• Store the Chain saw HCH5011 in the dry state
Information
Frequent lubrication will extend the life of the diamond chain and the bar.
Information
In order to avoid frost damage, if there is a danger of frost once work is
complete or prior to extended breaks in work the entire water system
must be emptied and blown out.