Luminex MasterPlex CT Tutorial Manual - Manual (Page 13)

http://www.miraibio.com Plex CT 13
The next step takes you through the
Alcohol Flush, which removes air
bubbles from the cuvette. In this
step, you can specify the location of
your reagent, in this case 70%
isopropanol. To do this, click on the
Location button, which in this case
is currently labeled Reservoir. The
plate window will pop up allowing
you to specify the plate type and well location of your reagent. Specify the Number of
Cycles for the Alcohol Flush and click on the Alcohol Flush button to execute the
command. Once the Alcohol Flush is done, click on Next proceed.
The last step of the Startup Wizard
takes you through the Wash step,
which clears out debris and dust
particles from the system. You can
specify the Location of your reagent,
which in this case is distilled water,
and the Number of Cycles to repeat.
Press the Wash button after you
have made your settings and the
Wash procedure will begin. When
you are done with the wash step,
press the Next button to proceed.
Master