Magnum Venus Plastech PUTTY UNIT - Manual (Page 17)

Putty Unit Operations Manual
Rev. 07/2012 Page | 17
9. Attach ¼ inch air hose from regulator on manifold to flush tank or flush pump (see figures 5)
Fig. 5
10. Connect the Putty Hose
Fig. 9
Pre Startup Instructions:
1. Check all hoses for wear or damage, replace if necessary.
2. Check to be sure you have appropriate quantities of Putty material & Catalyst to complete the job.
3. Check and repair or replace any damaged items before starting a job.
4. Located on the Putty Ram unit check and adjust the Ram lower limit. By adjusting the APD-1011
bracket the RAM stop position can be adjusted (see “Adjust the Drum Low Level Limit” below).