Magnum Venus Plastech PUTTY UNIT - Manual (Page 15)

Putty Unit Operations Manual
Rev. 07/2012 Page | 15
Introduction:
Please make sure all appropriate personal protective equipment is used before start up of this unit. Refer
to and follow the requirements of the Material Safety Data Sheets supplied by your coating material
manufacturer for solvent, putty material and catalyst.
CAUTION: Always wear proper safety equipment (glasses, gloves, respirator, etc.) when working
on the dispensing equipment.
This manual, the Putty Unit Operations Manual, provides information you need to perform simple
maintenance and repair on your equipment.
Step-by-step assembly and disassembly procedures are included for each component.
This manual includes Installation, Start-up and Shut-Down instructions.
Step-by-step assembly and disassembly procedures are included for each component.
Please read this manual carefully. Follow the steps in the order given, otherwise you may damage the
equipment or injure yourself.
Component Assemblies:
The Putty Unit consists of a number of components – these components will have their own detailed
manuals and drawings. For complete repair and maintenance instruction please reference these manual.
HV Pro Gun Repair Manual – Pour Unit
or
Classic Pro Gun Repair Manual – Spray Unit
Powerslide Powerhead Manual – Dual Rod – 5000 & 7000 Series
CPPLS-1000 Chop Check Fluid Section Manual
VHPC-1000 Metering Pump Manual – PHPC-7200
Air Requirements:
1. The system requires a supply of air (30cfm) and at least 100 psi.
2. We require a 1/2" inch (12-13mm) inside diameter air hose minimum (Use caution when using quick
disconnects as they may restrict air flow.
3. Preferably the air will be clean, dry and oil free.