Magnum Venus Plastech PUTTY UNIT - Manual (Page 16)

Putty Unit Operations Manual
Rev. 07/2012 Page | 16
Assemble the unit:
1. Swing up and attach the Catalyst Manifold and Bracket to the support bar.
2. Connect the Catalyst Hose from the catalyst pump outlet to the Catalyst Manifold.
3. Install the Catalyst Jug into the into Catalyst Jug bracket.
4. Connect the poly tube from the Catalyst Relief Valve to the top edge of the Catalyst Jug
5. Connect the poly tube from the Catalyst Dumb Valve to the top edge of the Catalyst Jug
6. Connect the Catalyst Feed Tube to the Catalyst Jug – measure and cut the feed tube then install
onto the Catalyst Pump Inlet fitting.
7. Attach the Flush Tank Bracket to the main post and install Flush Tank (see Fig. 2)
Fig. 2
Hose Connections:
8. Attach Flush Tube (solvent to the gun) to the outlet (SOLVENT) side of the flush tank (see Fig. 4)
Fig. 4