beautypg.com

Magnum Venus Plastech PATRIOT CHOP CHECK IMP-PAT-CCP-MP-5 User Manual

Page 33

background image

Patriot Putty Unit Operations Manual

Rev. 08/2012

Page | 33


Result 4:
Material delivered at the top and bottom of the stroke is hot (curing very rapidly). Also thin areas of
material might be noticeable compared to the volume delivered in the middle of the stroke, see figure
above.

Indicates: Low resin at the top (T) and bottom (B) of the pump stroke.

Probable Cause: There is no or improper accumulation effect in the resin system.

Solution: Resin accumulator full of hard material or has a blockage. Clean resin filter and
reinstall. Incorrect accumulator installed. Pump pressure is too high, lower resin pressure.