Magnum Venus Plastech Flex Molding Process IVX3 INJECTION VALVE 8010 - Manual (Page 27)

IVx3 Injection Valve Manual
Rev. 03/2012 Page | 27
9. Pull the Actuator Piston Assembly, shown below, from the Int Cylinder Body
(6974).
10. Remove the Lower Spring (7040) from the INT Cylinder Body.
11. Replace the two Lip Seals (5836) on the Actuator Piston Assembly and lightly
coat with MOLYKOTE 111 or SUPERLUBE grease.
12. Replace the O-ring (7044) lubricated with MOLYKOTE 111 or SUPERLUBE
grease in the Actuator Bottom Bush (6983).
Actuator & Valve Assembly:
1. Install the Lower Spring (7040) onto the Lower Shaft (6977) of the Actuator
Piston (6973) and push the assembly into the Int Cylinder Body (6974). The
Lower Shaft goes through the hole in the bottom of the Int Cylinder Body.
2. Pushing firmly screw the Int Cylinder Cap (6975) onto the Int Cylinder Body,
using the IVX3 Tools A & B, snug the Cap tight.
3. Install the Actuator INT Cylinder Body assembly with new Lip Seals (7039) into
the Cylinder Body (6981) – the Lower Shaft (6977) will go through the Bottom
Bush (6983).
Int Cylinder Cap
Int Cylinder Body
IVX3 Tool A
Actuator Piston Assembly
Lower Spring
IVX3 Tool B
Cylinder (6981)
Int Cylinder Body (6974)