Magnum Venus Plastech Flex Molding Process IVX3 INJECTION VALVE 8010 - Manual (Page 22)

IVx3 Injection Valve Manual
Rev. 03/2012 Page | 22
Note: It is important to follow the following steps carefully to ensure the seal is
not damaged during the installation process.
11. Apply Red Grease (6706-2-1 1oz) to the Seal
– Hard Wearing (7052) to ensure
that it is well lubricated.
12. Put the Valve into the Off mode by removing the air signal from the upper port.
This will pull the new seal partially back into the Upper Valve Body (6985).
13. Remove the Lower Valve Body (6986) positioned to assist the maintenance
process by unscrewing the single Machine Screw (7057).
14. Carefully reinstall the Lower Valve Body (6986) over the Upper Valve Body
(6985); press firmly over the Seal
– Hard Wearing (7052).
15. Install the two Machine Screws (7057) through both Valve Bodies and tighten
into the Actuator Cylinder (6981).
16. Actuate the valve to the Purge position and then to the Off position.
17. Actuate the valve the Inject position and then to the Off position.
18. Repeat steps 16 & 17 a number of times to correctly seat the seal and check for
correct valve operation.
Note: Allow proper drying time for the thread lock compound before using the
valve assembly.