Magnum Venus Plastech UltraMAX VLS-2400 Series - Manual (Page 31)

VLS-2400 Series Fluid Section Manual
Rev. 08/2013 Page | 31
To Reinstall onto Unit:
Note: the following instruction will vary slightly depending on the Fluid Section you are
working on.
1.
Fasten the Fluid Section Assembly to the Pump Mount Plate Assembly using the
four Hex Head Bolts (F-HB-06C-24-GR8).
2. Position the Sleeve over the Power Cylinder Piston Shaft. Bring the Power Cylinder
Piston Shaft down onto the top of the Piston Rod Adapter. Insert the two
Connectors and lower the Sleeve. Install the Ring in machined groove.
3. Slide the Rail Assembly around the Piston Rod Adapter and insert the Quick Pin.
4. Fill the packing nut cavity 1/2 to 2/3 full with the proper lubrication -
o TSL-800 1/2 PINT
o TSL-3200 1 QUART
o TSL-1280 1 GALLON
or
o PAT-LS-OIL 8 ounces
o PAT-LS-OIL-1GL 1 Gallon
o PAT-LS-OIL-5GL 5 Gallons
or
o TSL-ISO-800 8 ounces
Set The Packing Set:
1. Prime the Fluid Section with fluid.
2. Close the gun-head.
3. SLOWLY increase the pump pressure to 60 - 80 psi. It will be necessary to push
and hold the priming button if one is installed on this unit.
4. Keep the pump stalled for 5 to 15 minutes to allow the packing set to set.
5. Perform the above procedures for both the up and down strokes.
Note: If the pump is slowly moving while it should be stalled it indicates that the
there is a leak past the ball or seals (up stroke)
6. Decrease the pump pressure to the desired operating pressure. Now you are
ready to connect, prime and pressurize the catalyst pump for operation.