Magnum Venus Plastech UltraMAX VLS-2400 Series - Manual (Page 23)

VLS-2400 Series Fluid Section Manual
Rev. 08/2013 Page | 23
SIX MONTH MAINTENANCE CHECKLIST:
PART PROCEDURE
Ai r Filter (“Water Trap”) Drain.
Hoses Check for kinks or leaks.
Gauges and Regulators Check for damage and proper operation.
Accumulator Remove and clean inside. Replace the O-Rings. Danger:
Never attempt to remove an accumulator until you have
relieved pressure. See Accumulator & Filter section pg. 31.
Filter Clean and inspect filter screen for plugging. Note: Clean
the screen weekly and when changing from one
material to another. Use proper screen mesh size
according to the material being used.
Fluid Section Replace the oil in the oil reservoir. If necessary, clean and
dry the silencers. Check piston rod, cylinder head, piston
and trip sleeve for wear and damage, replace as needed.
Replace O-Rings, cups, and packing set. Check the pickup
hose and wand for leaks and damage. Check for packing
leaks. Check piston rod and pump cylinder for wear,
replace as needed. Replace the packing set, piston cups
and O-Rings.
Catalyst Jug Check and clean tubes and filter screens if necessary.
Danger: Fire and explosion hazard. Never allow
solvent or grease to contact any part of the catalyst
system.
Air Lines Check for leaks, wear and kinks. Replace if necessary.
Catalyst Pump Replace all soft parts of the catalyst pump. Be sure to:
check bushings and pump cylinder and replace S.S. balls,
O-Rings, springs, piston seal and packing set.