Magnum Venus Plastech UltraMAX VLS-2400 Series - Manual (Page 20)

VLS-2400 Series Fluid Section Manual
Rev. 08/2013 Page | 20
j. Cut the ½ inch diameter poly line, with the clamps, to 26 inches long. Clamp one end to
the outlet of the catalyst jug and the other end to the inlet of the catalyst pump. Make
sure clamps are airtight.
k. Connect the ¼-inch poly line to the relief valve on the catalyst manifold assembly and
insert the other end into the hole in the top of the catalyst jug.
l. Connect the ¼-inch poly line to the catalyst recirculation valve on the catalyst manifold,
and insert the other end into the hole in the top of the catalyst jug.
8.
Check all components for damage.