beautypg.com

Magnum Venus Plastech PATRIOT 10:1 ADHESIVE SYSTEM User Manual

Page 29

background image

Patriot 10:1 Adhesive System Operations Manual

Rev. 03/2014

Page | 29

4.

Turn Air Lift

control lever to “up” position (see figure 26).








Figure 26










5.

Adjust pressure regulator marked Air Life to 20 psi

6.

Hold pail down if it beings to lift, close and open the Air Lift lever intermittently to raise follower and
pump out of pail.


7.

It may be necessary to adjust both ram / Air Lift and ram extraction pressures accordingly to
necessitate removal without lifting the pail.

8.

After pump and follower are removed, inspect, seal and dispose of plastic boot

9.

Clean any build up of material on follower gasket as well as follower plate

10.

Replace with “new” pails and refer back to procedures for priming.