Liquid Controls SCAMP - Manual (Page 2)

2
TABLE OF CONTENTS
SUBJECT PAGE
Table of Contents.............................................................................................................. 2
Overview ........................................................................................................................... 3
Installing SCAMP and Making Basic Electrical Connections ............................................ 4
Powering Up SCAMP........................................................................................................ 4
Programming Meter k-Factor ............................................................................................ 5
Computing and Programming Multi-Point Calibration Data (Optional)........................ 6 – 9
Temperature Volume Compensation (Optional) ..................................................... 10 – 11
Fault Indicator/Electromechanical Totalizer (Optional) ................................................... 12
Final Checkout Flow Test................................................................................................ 12
Error Messages....................................................................................................... 13 – 14
Trouble Shooting............................................................................................................. 15
Appendix A, Specifications.............................................................................................. 16
Appendix B, SCAMP Function Tables ............................................................................ 17
Appendix C, Calculating the k-Factor for your Meter ...............................................18 - 19
Appendix D, Nominal Raw Pulser Resolution of LC Meters …..………………………….19
Electrical Safety
NOTE: This equipment is suitable for Class I, Division 2, Groups C and D, or non-
hazardous locations, only.
Electromagnetic Compatibility Limitation
NOTE: This (equipment and/or system) is suitable for use in all establishments other
than domestic and those directly connected to the low voltage power supply network
which supplies buildings used for domestic purposes.
WARNING
The SCAMP TM circuit board and attendant equipment including but not limited to 9-18
VDC power supply, 2-channel quadrature pulser, and electronic counter (whether
supplied by Liquid Controls or others) must be installed and operated in accordance with
all applicable national and local electrical, environmental, and safety codes. Failure to
do so could result in serious injury or death.
Explosion Hazard – Substitution of components may impair suitability for Class I,
Division 2.
Explosion Hazard - Do not disconnect equipment unless power has been switched off
or the area is known to be non-hazardous.
NOTE: The rotary data switches on SCAMP can be damaged by extensive or rough
rotation of the mechanism. Please exercise appropriate care when setting all data
values on the rotary switches.
TOOLS REQUIRED: Small flat-blade screwdriver for attaching wires to terminal strips
and making adjustments to rotary switches.