Ata/ide configuration [enhanced, Defaults) – Asus 1U Rackmount Barebone Server RS120-E3 (PA4) User Manual

Page 81

A S U S R S 1 2 0 - E 3 / P A 4

5 - 1 5

ATA/IDE Configuration [Enhanced]

Allows selection of the IDE operation mode depending on the installed operating
system (OS). Set to [Enhanced] mode if you are using native OS, e.g. Windows

Server 2000/2003. Set to [Compatible] mode if you are using legacy OS,
e.g. Windows ME/98/NT, MS-DOS. Configuration options: [Disabled]
[Compatible] [Enhanced]

5.3.4

IDE Configuration

The items in this menu allow you to set or change the configurations for the
IDE devices installed in the system. Select an item then press if you
want to configure the item.

The Configure SATA As

Configure SATA As

Configure SATA As and Third IDE Master/Slave

Third IDE Master/Slave

Third IDE Master/Slave items appear

only when you set the ATA/IDE Configuration to [Enhanced] mode.

Configure SATA As [IDE]

Sets the configuration for the Serial ATA connectors supported by the
Southbridge chip.

If you want to use the Serial ATA hard disk drives as Parallel ATA physical
storage devices, set this item to [IDE].

Set this item to [RAID] if you want to create a RAID volume from Serial
ATA hard disk drives.

Place a jumper cap on pins 1-2 of the RAID_SEL1

R A I D _ S E L 1

R A I D _ S E L 1 jumper to use the LSI

Logic Embedded SATA RAID Utility (for RAID 0, RAID 1, or RAID 0+1
configuration; supported on Windows

2000/2003 Server/XP and Red

Hat

Enterprise ver. 3.0). Refer to section 4.2 Jumpers

4.2 Jumpers

4.2 Jumpers for details.

Place a jumper cap on pins 2-3 of the RAID_SEL1

RAID_SEL1

RAID_SEL1 jumper to use the Intel

Matrix Storage Manager (for RAID 0, RAID 1, RAID 0+1, or software RAID 5
configuration; supported on Windows

2000/2003 Server/XP).

IDE Configuration

ATA/IDE Configuration

[Enhanced]

Configure SATA As

[IDE]

Primary IDE Master

[ATAPI CD-ROM]

Primary IDE Slave

[Not Detected]

Secondary IDE Master

[Not Detected]

Secondary IDE Slave

[Not Detected]

Third IDE Master

[Not Detected]

Third IDE Slave

[Not Detected]

Fourth IDE Master

[Not Detected]

Fourth IDE Slave

[Hard Disk]

IDE Detect Time Out (Sec)

[35]

Select Screen
Select Item

Change Option

General Help

F10 Save and Exit
ESC Exit

BIOS SETUP UTILITY

Main

Set[Compatible Mode]
when Legacy OS(i.e.
WIN Me, 98, NT4.0, MS
DOS)is used.
Set[Enhanced Mode]
when Native OS(i.e.
Win2000, WIN XP)is
used.

(Defaults)

This manual is related to the following products:

RS120-E3/PA4