Asus 1U Rackmount Barebone Server RS120-E3 (PA4) - Manual (Page 31)

2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5 A S U S R S 1 2 0 - E 3 / P A 4 A S U S R S 1 2 0 - E 3 / P A 4 A S U S R S 1 2 0 - E 3 / P A 4 A S U S R S 1 2 0 - E 3 / P A 4 A S U S R S 1 2 0 - E 3 / P A 4
2.5.2 2.5.2 2.5.2 2.5.2 2.5.2 Reinstalling the riser card bracket Reinstalling the riser card bracket Reinstalling the riser card bracket Reinstalling the riser card bracket Reinstalling the riser card bracket
To reinstall the riser card bracket:
1. Take note of the holes on the riser card bay. The three pegs on the riser
card bracket should match these holes to ensure that the bracket is
properly in place.
2. Install the riser card bracket with
the card into the PCI Express x8
and PCI-X slots on the
motherboard.
P e g s o n t h e r i s e r P e g s o n t h e r i s e r P e g s o n t h e r i s e r P e g s o n t h e r i s e r P e g s o n t h e r i s e r
c a r d b r a c k e t
c a r d b r a c k e t c a r d b r a c k e t c a r d b r a c k e t c a r d b r a c k e t
3. Press the riser card bracket until
the golden connectors completely
fit the slot and the bracket aligns
with the rear panel.
4. Connect the cable(s) to the card,
if applicable.