Asus 1U Rackmount Barebone Server RS120-E3 (PA4) - Manual (Page 20)

C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p 2 - 4 2 - 4 2 - 4 2 - 4 2 - 4
2. Firmly hold the cover and slide it
toward the rear panel for about half
an inch until it is disengaged from
the chassis.
5. Lift the cover from the chassis.
2.1.3 2.1.3 2.1.3 2.1.3 2.1.3 Installing the top cover Installing the top cover Installing the top cover Installing the top cover Installing the top cover
1. Position the cover on top of the
chassis with the thumbscrews on
the rear, and leaving a gap of about
half an inch from the front panel.
3. Slide the cover toward the front until it snaps in place.
4. Tighten the thumbscrews on the rear to secure the cover.
2. Make sure that the side markings
on the cover (two on each side)
are aligned to the grooves on the
chassis.
G r o o v e s G r o o v e s G r o o v e s G r o o v e s G r o o v e s
S i d e m a r k i n g s S i d e m a r k i n g s S i d e m a r k i n g s S i d e m a r k i n g s S i d e m a r k i n g s
T h u m b s c r e w s T h u m b s c r e w s T h u m b s c r e w s T h u m b s c r e w s T h u m b s c r e w s
1 / 2 i n c h 1 / 2 i n c h 1 / 2 i n c h 1 / 2 i n c h 1 / 2 i n c h
d i s t a n c e
d i s t a n c e d i s t a n c e d i s t a n c e d i s t a n c e