Controlled Products Systems Group 0-205679 User Manual

Page 64

4.2.2.E Programming Card ONLY Use

Card ONLY use can be programmed with command
50. The programming sequence is as follows:

50 # user-type # user location # **

4.2.2.F Programming Code OR Card

Finally, you can program a user for either Code OR
Card use as follows:

52 # user-type # user location # keypad
PIN* keypad PIN *

Chapter 4: Programming

4.2 Programming Users

4-12

prox.pad plus Install/Program. Manual, PPP, D4b

Part No. 6105679, Rev. 1.1