Controlled Products Systems Group 0-205679 - Manual (Page 11)

1.8 Items Supplied
from the Factory The following items are supplied from the factory with
the initial prox.pad plus shipment.
•
Controller with Keypad, Faceplate, Request to Exit
(REX) button (also called the “Filler Piece”), three Wire
Harnesses, and various installation Screws.
1.9 Items the
Installer Must
Supply For each initial prox.pad plus unit installation, the
installer must supply the following items:
•
The prox.pad plus unit works with these four types of
cards:
– Prox Card II
– IsoProx II
– Duo Prox II
– Proxkey FOB
•
a filtered and regulated 12VDC power supply
•
the appropriate installation electrical tools
•
the recommended remote antenna cable
[ALPHA 1174C (22AWG) 4-wire, stranded] (this is re-
quired ONLY if you choose to remote the antenna a
maximum 10 feet away from the keypad/controller)
•
RS-485 cable (24AWG), shielded, two twisted-pair tele-
phone cable with a shunt capacitance of
16 pF/Ft (required only when using software)
•
power supply cable (18AWG-22AWG) 2-wire stranded
(depends on distance)
•
door lock cable (18AWG-22AWG) 2-wire stranded (de-
pends on distance)
•
door monitor cable (18AWG-22AWG) 2-wire stranded
(depends on distance)
•
REX cable (if using remote switch) 2-wire stranded
•
For PC programmed and managed systems (not re-
quired in applications where programming is accom-
plished at the prox.pad plus keypad):
– Hub Manager™ Professional access control soft-
ware version 5 or higher with PC meetings re-
quirements shown on inside of front cover
– RS-232 to RS-485 interface installed on the PC
COM port, which converts RS-232 communica-
tions to RS-485 (IEI model IEI232-485; part
number 0295093)
1.8 Items Supplied from the Factory Chapter 1: Introduction
prox.pad plus Install/Program. Manual, PPP, D4b 1-3
Part No. 6105679, Rev. 1.1