Controlled Products Systems Group ECUMSING5 - Manual (Page 7)

VIKING TECHNICAL SUPPORT 1.800.908.0884 5
PARTS DIAGRAM/PARTS LIST 2
ECU BOX DIMENSIONS 3
CONTROL BOARD REFERENCES 4
IMPORTANT SAFETY INFORMATION 6-12
Important Safety Instructions 6
Important Installation Instructions 7
Maintenance 8
General Safety Precautions 8-9
Operator Classification 9
Photo Beam (non-contact sensor) Installation 10
Edge Sensor (contact sensor) Installation 11
Audible Alarm Reset Installation 12
Warning Placard Installation 12
IMPORTANT INSTALLATION INFORMATION 13
Specifications 13
ECU Box Installation 13
ELECTRICAL INSTALLATION 14-16
High Voltage Supply Option 14
Low Voltage Supply Option 15
Solar Supply Option 15
Motor Harness 16
LIMIT INDICATIONS 17
CONTROL BOARD SETUP 18-21
Initial Settings 18-19
Obstruction Detection Sensor (Primary Entrapment Protection) 20
Viking Heater.......................................................................................................................... 21
ACCESSORY CONNECTIONS 22-28
Re-Open Photo Beam (Vehicular Safety) 22
Radio Receiver (Typical) 23
Anti-Tail Gate, Open Commands, Guard Station
24
Viking Loop Rack 25
Guidelines for Loop Installations
26
Magnetic Lock, Lock Solenoid 27
Barrier Arm (B-12) Synchronization Option 28
TROUBLESHOOTING 30-35
LED References 30-31
LCD Display References 32-34
Solutions
35
APPENDIX A, B & C 36-39
VIKING EXPANSION PRODUCTS 40
PARTS DIAGRAM/PARTS LIST 2
ECU BOX DIMENSIONS 3
IMPORTANT INSTALLATION INFORMATION 13
ELECTRICAL INSTALLATION 14-16
LIMIT INDICATIONS 17
CONTROL BOARD SETUP 18-21
ACCESSORY CONNECTIONS 22-28
TROUBLESHOOTING 30-35
VIKING EXPANSION PRODUCTS 40
APPENDIX A, B & C 36-39
CONTROL BOARD REFERENCES 4
IMPORTANT SAFETY INFORMATION 6-12
TABLE OF CONTENTS: