Controlled Products Systems Group ECUMSING5 - Manual (Page 32)

VIKING TECHNICAL SUPPORT 1.800.908.0884 3 0
LED References
In addition to the LCD Display, the control board LEDs monitor the various circuits of the
control board. Use the table below to identify the corresponding “TS Ref#” and refer to
page 32-35 for further troubleshooting.
TROUBLESHOOTING
# LED Status Meaning
Page 35
TS Ref#(s)
1 “Magnetic
Lock” OFF At Closed Limit and Magnetic Lock Relay state is closed across “COM” &
“N.C”. (page 27). Gate should be at the Close Limit.
SOLID Not at Closed Limit and Magnetic Lock Relay state is closed across “COM” &
“N.O”. (page 27). Gate should not be at the Close Limit
2 “Check Motor” OFF Normal Condition.
SOLID The control board is sending power to the motor but this circuit is not
complete or closed.
7, 8
3 “Battery Low” OFF Normal Condition.
SOLID Batteries are low. Check power supply to the operator. (pages 14-15). 1, 2
FLASHING Batteries critically low. Check power supply to the operator. (pages 14-15). 1, 2
4 “POWER” SOLID Normal Condition.
FLASHING Operator is running on batteries only (pages 14-15). 1, 2
OFF No power to control board. 1, 2, 4, 5
5 “Radio” OFF Normal Condition.
SOLID Control Board is receiving an input from a device connected to the
Radio terminal (pages 23, 36).
9, 10
6 “UL” OFF Normal Condition.
SOLID Control Board is receiving an input from a device connected to the UL
terminal (pages 12-13, 36).
9, 10
7 “Re-Open” OFF Normal Condition.
SOLID Control Board is receiving an input from a device connected to the Re-
Open terminal (pages 22, 25, 36).
9, 10
8 “ATG” OFF Normal Condition.
SOLID Control Board is receiving an input from a device connected to the ATG
terminal (pages 24, 36).
9, 10