Controlled Products Systems Group AOMSW300 - Manual (Page 4)

*Confirm that the gate operator being installed is appropriate for the application.
*Confirm that the gate is designed and built according to current published industry standards.
*Confirm that all appropriate safety features and safety accessory devices are being incorporated,
including both primary and secondary entrapment protection devices.
*Make sure that the gate works freely before installing the operator.
*Repair or service worn or damaged gate hardware before installation of the operator.
*Eliminate all gaps in a sliding gate below a 4 foot height that permits a 2 ¼ inch sphere to pass
through any location, including the area of the adjacent fence covered when the gate is in the open
position.
*Eliminate all gaps in a swinging gate below a 4 foot height that permit a 4 inch sphere to pass
through any location, including the hinge area of the gate.
*Operator must be disconnected from the power source before attempting any installation of
accessories.
*Install this gate operator according to our installation instructions.
*Adjust the operator clutch or load sensing device to the minimum force setting that will still allow
for reliable gate operation.
*Install the operator inside the fence line(do not install the operator on the public side of fence line).
*Install a proper electrical ground to a gate operator.
*Install controls where users cannot touch or reach through the gate to operate the controls.
*Install all warning signs and take pictures of the installation.
*Test all safety features for proper function before placing the automatic vehicular gate into service.
*Train owner/users about basic functions and safety features of the gate system, including how to
turn off the power and how to operate the manual disconnect feature.
*Leave safety instructions, product literature, installation manual and maintenance manual with
end user.
*Explain to the owner/user the importance of routine service and retesting on a monthly basis.
I NSTALL THE GATE OPERATOR ONLY WHEN YOU
HAVE READ THE FOLLOWING:
5