Controlled Products Systems Group AOMSW300 - Manual (Page 10)

15
ARM LAYOUT & OPERATOR
PLACEMENT CONTINUED
Hinge point
Bracket
Bracket
Center shaft of
Operator
3
Measure distance from the
Y
Z.
point
And point Say distance is 60”,
divide this number by 2,which =30”.
This is the length of primary arm in
next drawing.
PLEASE BE EXACT!!!
4
+
+
T his ARM section is half the
distance between point
and point
as shown above.
Y
Z
IT MUST BE EXACT!!!
This pipe does not need
to be measured after
primary arm is installed
this pipe makes up the
balance of arm.
PRIMAR
Y ARM
SECTION
CENTER OF
BOLT AT FIRST
HINGE POINT
CENTER OF
SHAFT ON
OPERATOR
X
X
Point
Y
Point
Z