Important safety instructions, Save these instructions – Controlled Products Systems Group 1550ETL-1K User Manual
Page 3
3
WARNING - To reduce the risk of injury or death:
xx
READ AND FOLLOW ALL INSTRUCTIONS.
x
Installation should be performed by a professional installer.
x
Required welding should be performed by a qualified welder.
x
Should electricity be required, use a certified electrician only.
x
Any device that requires 120 Volts AC should be U.L. approved.
x
Review with the owner all safety concerns including:
Do not operate the gate unless area around gate is in full view.
Never let children operate or play with gate controls. Keep the remote
control away from children.
Always keep people and objects away from the gate. NO ONE SHOULD
CROSS THE PATH OF THE MOVING GATE.
Periodically test the obstruction sensitivity to assure safe and proper
operation. Do not test sensitivity by standing between the gate and the
hinge or stop post.
The “CAUTION AUTOMATIC GATE” signs should be clearly visible from
both sides of the gate.
Always insure that the gate has closed securely before leaving area.
Arrange with local fire and law enforcement for emergency access.
x
Use the emergency release only when the gate is not moving.
x
A secondary entrapment device such as loop detectors, edge switches, and
beam detectors are highly recommended and required to meet the UL325
standard.
x
Install control devices such as keypads far enough away (5 feet or further)
from any moving parts of the operator and gate to prevent possible injury.
x
Do not install control box where the gate can come in contact with person us-
ing the push button on side of control box.
x
Always disconnect the battery or power source when making adjustments or
repairs to any part of the gate or operator.
x
All rollers should be covered to prevent injury.
x
KEEP GATES PROPERLY MAINTAINED. Read the owner’s manual. Have a
qualified service person make repairs to gate hardware.
x
The entrance is for vehicles only. Pedestrians must use separate entrance.
Test the gate operator monthly. The gated entrance MUST reverse on contact
with a rigid object or stop when an object activates the non contact sensors. Af-
ter adjusting the force or limit of travel, retest the gate operator. Failure to adjust
and retest the gate operator properly can increase the risk of injury or death.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
II