CNB NXE3055VR - Manual (Page 32)

XNET User Manual
32 / 54
ITEM DESCRIPTION
IP Address
Configuration
Obtain an
IP Address
automatically
(DHCP)
Turns DHCP on or off.
Check DHCP checkbox to get an IP address automatically from the
network using DHCP protocol.
Obtained IP address can be viewed by IP Installer.
If the network does not use DHCP server, the product
will wait for server’s response for two minutes and
restart with its previous IP address (192.168.123.100).
Please modify Camera’s IP address with IP Installer
program.
IP address
Enter an IP address.
Configure IP address after checking IP address range configuration of
the router where the XNET product is connected.
Subnet mask
Enter Subnet mask.
Use this when you want to access only from the same subnet by
masking out upper portion of the IP address.
Use 255.255.255.255 when you want to connect from one PC only.
Default
Gateway
Enter the address of Default Gateway.
DNS
Configuration
Primary
DNS Server
Enter primary DNS address.
Secondary DNS
Server
Enter secondary DNS address.
NTP
Configuration
NTP Address
Enter address of NTP (Network Time Protocol Server).
NTP server is used when『Synchronize with NTP Server』is selected
in Date & Time page.
Host name
Configuration
User
the Host name Enter Host Name.
MAC Address
MAC Clone Enter Ethernet Address.
Reset MAC
Address
Initializes the Camera’s Ethernet Address.
Save - Applies and saves the configurations.
Reset - Recalls previously the saved configurations.