Kolpin 53570 - Stealth Exhaust 2.0 & Heat Shield - Manual (Page 9)

Rev. 1
YAMAHA GRIZZLY INSTALLATION
1. 2. 3.
1. Place the number 58 bushing onto the OEM outlet.
2. Slide the Stealth Exhaust inlet onto the Number 58 bushing. Tighten using the 1 3/8” Muffler clamp. Use
orange hi-temp silicone on all connections for maximum noise reductions.
3. The mounting strap will need to be custom bent for supporting the muffler. Here we place the mount on the
back side of the muffler. We leave the attachment method open to the consumer so you can custom fit your
machine based on how you use it.
4. The Kolpin Heat Shield (53560) has been attached to prevent anyone from touching the hot exhaust.
POLARIS RANGER 6 x 6 INSTALLATION
1. Install the number 58 and 59 bushings on the outlet of the OEM muffler.
2. Cut the elbow adapter to fit from the OEM outlet to the Stealth Exhaust 2.0.
3. Clamp using two 1 ½” Muffler Clamps connecting the OEM muffler to the Stealth Exhaust 2.0. Use orange
hi-temp silicone on all connections for maximum noise reductions.
4. The Mounting Strap will need to be attached to the frames cross members under the dump bed.
5. Be sure to leave adequate room from any wires running under your bed.
POLARIS SPORTSMAN XP
1. First, cut the “L” shaped tube so that it can be used as a straight adapter pipe as shown below. (Photo 1)
2. Cut 2 slots, approximately ¾”, down the sides of the pipe you just cut, similar to the cuts on the Stealth. Be
sure not to cut the slots too long as the system will not seal correctly!
2. Now, clamp the Kolpin Stealth Exhaust to the OEM Muffler using the pipe you just cut and (2) of the 1.50”
U-Bolt Clamps provided. (Photo 1)
3. Next, take the largest R shaped mounting clamp and widen out to fit around the OEM Bar at the rear of the
machine. (Photo 2)
4. Now, place the bands around the muffler to see how the mounting strap will need to be cut as shown below.
(Photo 3)
5. Cut the mounting strap to fit.
6. Tighten all hardware securely.
1. 2. 3.