INTELLINET NETWORK 525251 300N High-Power PoE Access Point User Manual - Manual (Page 70)

64
2-10-3 DHCP Server
This wireless access point is able to act as a DHCP server for your
network, and it’s disabled by default. If you want to activate this
function, click System Utility on the left side, and the following
message will be displayed:
Here are descriptions of every setup item:
Default Gateway
IP
Input the IP address of the default gateway of
your network here.
Domain Name
Server IP
Input the IP address of the domain name
server (DNS) here.
Start IP Input the start IP address of the IP range.
End IP Input the end IP address of the IP range.
Domain Name You can also input the domain name for your
network. This is optional.
Lease Time From the drop-down menu, choose a lease
time (the duration that every computer can
keep a specific IP address) of every IP
address assigned by this access point.
NOTE: Remember to select “Enable” in the “DHCP Server”
option as described in the last section or all DHCP-related
fields will be grayed out and you will not be able to input
any DHCP parameters.