INTELLINET NETWORK 525251 300N High-Power PoE Access Point User Manual - Manual (Page 43)

37
Here are descriptions of every setup item:
Band
Select the wireless band you wish to use. By
selecting different band settings, you’ll be able
to allow or deny the wireless client of a certain
band.
If you select 2.4 GHz (B), 2.4 GHz (N), or 2.4
GHz (G), only wireless clients using the
wireless band you select (802.11b, 802.11 N or
802.11g) will be able to connect to this access
point.
If you select 2.4 GHz (B+G), then only wireless
clients using 802.11b and 802.11g bands will
be able to connect to this access point.
If you want to allow 802.11b, 802.11g and
802.11 N clients to connect to this access
point, select 2.4 GHz (B+G+N).
MAIN SSID Input the ESSID (the name used to identify this
wireless access point) here. You can input up
to 32 alphanumerical characters. NOTE:
THE ESSID IS CASE SENSITIVE.
Multiple ESSID The access point supports multiple SSID
functions; up to four SSIDs can be set. If you
want to configure additional SSIDs, click this
button. For detailed descriptions of the
function, refer to Section 2-4-1-1.
Channel
Number
Select a channel number you wish to use. The
channel number must be the same as another
wireless access point you wish to connect to.
Associated
Clients
Click “Show Active Clients” and a new popup
window will appear that contains information
about all wireless clients connected to this
access point. You can click “Refresh” in the
popup window to keep information up to date.
Root AP SSID In Universal Repeater mode, this device can