INTELLINET NETWORK 525251 300N High-Power PoE Access Point User Manual - Manual (Page 14)

8
2-2 Connecting to wireless access point by Web browser
After the network connection is made, the next step is to set up the
access point with proper network parameters so it can work
properly in your network environment.
Before you can connect to the access point and start configuration
procedures, your computer must be able to get an IP address
automatically (use a dynamic IP address). If it’s set to use a static
IP address, or if you’re unsure, follow the instructions below to
configure your computer to use a dynamic IP address:
If the operating system of your computer is….
Windows 95/98/Me - Go to section 2-2-1
Windows 2000 - Go to section 2-2-2
Windows XP - Go to section 2-2-3
Windows Vista - Go to section 2-2-4
2-2-1 Windows 95/98/Me IP address setup
1. Click the Start button (it should be located at lower-left corner of
your computer), then click Control Panel. Double-click the
Network
icon to display the Network window. Select “TCP/IP,”
then click “Properties.”