INTELLINET NETWORK 525251 300N High-Power PoE Access Point User Manual - Manual (Page 45)

39
2-5 WPS Setting
Wi-Fi Protected Setup (WPS) is the simplest way to build a
connection between wireless network clients and this access point.
You don’t have to select an encryption mode and input a long
encryption passphrase every time you need to set up a wireless
client: You only have to press a button on the wireless client and
this access point, and the WPS will do the setup for you.
This access point supports two types of WPS: Push-Button
Configuration (PBC) and PIN code. If you want to use PBC, you
need to switch this access point to WPS mode and push a specific
button on the wireless client to start WPS mode. You can push the
Reset/WPS button of this access point or click “Start PBC” in the
Web configuration interface to do this; if you want to use PIN code,
you need to provide the PIN code of the wireless client you wish to
connect to this access point and then switch the wireless client to
WPS mode. The detailed instructions are listed below.
To use the WPS function to set an encrypted connection between
this access point and a WPS-enabled wireless client, click “WPS
Setting” on the left side of the Web management menu and the
following information will be displayed:
NOTE: The WPS function of this access point will not work
for wireless clients that do not support WPS.